My question is very simple. At my office we have a Cisco 1811 router that is connected to our internal network. Dialer0 is connected to our ISP. We have a IPSEC tunnel running between one of the branch offices at a different location. Our 1811 is not a mainstream and we have a different firewall for the remote users. But the problem here is one of the workstations that's a MAC book would not connect to our firewall so i had to put him through 1811 to access our internal resources.
Since i am running an IPSEC tunnel on the dialer0 interface how do i configure Client access VPN and how do i map it to the dialer interface.
Your help is greatly appreciated
IOS support for direct LDAP integration was recently released in 15.1. You can read more about it at the link below. Information regarding DHCP integration can be found at the second link.
Attached is a sample configuration that you can use to service both static site-to-site and dynamic remote access on the same router. Please let me know if you have any specific questions.