EIGRP Routing Problem

Unanswered Question
Sep 7th, 2010
User Badges:

Hi all,


I recently move sites to a VPLS provider.

I setup all routers to run EIGRP. This company have a particular setup between HQ and DR sites (Disaster & Recovery)

Please see attached.

The problem resides when I enable EIGRP in the inside interface in the DR router, all the other locations seems to start dropping connectivity.

I think this is because all remotes locations have two paths to the bridge network behind the HQ and DR routers, and causes a loop.

I would like to have HQ router as the primary router and DR router as my backup path to the bridge network.


Thanks in advance for your feedback.

Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Tue, 09/07/2010 - 13:30
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Aosondoval,


on DR router you should use the offset-list feature in order to make its routes with an higher metric


access-list 11 permit any


router eigrp XX


offset-list 11 out 100


the command will increase the delay component of EIGRP routes sent out the specified interface



see


http://www.cisco.com/en/US/docs/ios/iproute_eigrp/command/reference/ire_i1.html#wp1035554


Hope to help

Giuseppe

Actions

This Discussion