I got some sort of a challenge over here. We have a couple of 521's which are standalone versions. Because of the limited functionality of the webinterface (and the fact that I configure all cisco's from the console) I am configuring them by hand.
The problem is that I cannot get them into configuration mode when I am connected through ssl. I tried all the tricks I know but no luck yet. I am logged in at privilege level 15 so I should be able to do anything, but no. What am I missing here? From the console there's no problem but when the AP's are mounted (above the ceiling) it would be nice to still be able to configure them if necessary without bringing the roof down every time.