Solved: simultaneous usage of both external & internal DHCP servers on one controller

Mariya Telitsina · ‎09-08-2010

Hello,

I have a WLC controller configured to use external DHCP server. Is it possible to use an internal DHCP server for another pool (external network) on a different physical interface, dynamic interface etc?

Thanks in advance

Surendra BG · ‎09-17-2010

create a SVI on the switch and configure the corresponding internal pool on the WLC.. this will do it.... make sure we are mapping the WLANs correctly..

Regards

Surendra

Regards
Surendra BG

View solution in original post

Surendra BG · ‎09-17-2010

create a SVI on the switch and configure the corresponding internal pool on the WLC.. this will do it.... make sure we are mapping the WLANs correctly..

Regards

Surendra

Regards
Surendra BG

Mariya Telitsina · ‎09-17-2010

yup, have already done this...

everything is working fine.

Thanks for reply.

davy.timmermans · ‎09-17-2010

if you want to use an external server: fill in the external DHCP IP in at the corresponding interface

if you want to use an internal server: fill in the management IP of the WLC

;-)

Mariya Telitsina · ‎09-17-2010

the thing was about using them both at the same time )

have already cleared that out. thanks.

George Stefanick · ‎09-19-2010

Just as a follow up. Here is the Cisco document for "DHCP with the WLC"

http://www.cisco.com/en/US/products/ps6366/products_tech_note09186a0080af5d13.shtml#DHCP-Proxy

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________