Problem using WRVS4400n with WPA4410n as Repeater

Unanswered Question
Sep 8th, 2010

hi there,


we're using a WRVS4400n with V2.0.0.8-ETSI as Router and WLAN Access.

- Network Mode: N-Only

- Channel: 13

- Secutity: WPA2

- Isolation: disabled

- Bandwith: 20/40

- Signal is allowed to be repeated


Now we installed a new WAP4410n with 2.0.3.3 as repeater to get a better connection in some places.

We configured the WAP with the same wireless setting as the Router, and also configured both with site survery,

so everything looked fine.


But if we unplug the ethernet from WAP we can't access him through the wlan.

LED  for WLAN is on but not blinkin so that it seems that there is no  traffic. Also the wireless connectivity did not getting better.


Hope someone can help us.


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion