UC540 Delay Sending Digits

Answered Question
Sep 8th, 2010
User Badges:

We've installed a Viking RC3 to handle remote door entry with the 540 product line.    Right now the Viking answers and then waits for the Cisco to enter digits, but the Cisco has already sent them..  I need it to wait to send the digits to triger the door release.

Does anybody have any experience making the UC delay it sending digits?  My demo kit is in repair, so no way for me to test...

Correct Answer by Brandon Buffin about 6 years 9 months ago

Try the following. I'm assuming this is the dial peer that points to the Viking device?


dial-peer voice 77712 pots
destination-pattern 77712
port 0/2/3
prefix ,,77712 (the commas insert a pause, you may have to experiment with the number needed)


Also, I notice the ephone-dn 1 (number 0001) is call forwarded to 7712, but the destination pattern above is 77712. Is one of these incorrect?


Hope this helps.


Brandon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Brandon Buffin Wed, 09/08/2010 - 10:53
User Badges:
  • Purple, 4500 points or more

How is the call being sent to the Viking device? FXO? FXS? Can you post your config?


Brandon

Correct Answer
Brandon Buffin Wed, 09/08/2010 - 12:04
User Badges:
  • Purple, 4500 points or more

Try the following. I'm assuming this is the dial peer that points to the Viking device?


dial-peer voice 77712 pots
destination-pattern 77712
port 0/2/3
prefix ,,77712 (the commas insert a pause, you may have to experiment with the number needed)


Also, I notice the ephone-dn 1 (number 0001) is call forwarded to 7712, but the destination pattern above is 77712. Is one of these incorrect?


Hope this helps.


Brandon

Actions

This Discussion