09-08-2010 11:52 AM
Hello , I need to know if it's possible to configure the Cisco SGE2000P switch so I can use a Cisco 7945 IP Phone for Voice and Data.
The configuration is easy with other 3560 switches we got but, a colleague bought this switch to install it in a warehouse with 10 IP Phones and we cannot make it work with separate vlans (one for voice and one for data)
Any Ideas?
Thanks a lot.
Jose
Solved! Go to Solution.
09-09-2010 06:38 AM
Hi Jose,
Considering there is not CDP within the switch itself, you will probably have to tell the phones which VLAN they belong to.
I assume as a pre-requisite that the switch has configured both tagged and untagged vlans assigned to all ports, even the uplink ports.
Now assuming that is setup correctly, goto the phones themselves ;
1. press the settings button
2. unlock them with the keyboard command **#
3. set their Admin. VLAN Id to the tagged vlan number that is used for voice traffic. You will have to find that option , most likely under the Network Configuration settings.
Save those changes. See if that makes a difference.
regards Dave
09-09-2010 06:38 AM
Hi Jose,
Considering there is not CDP within the switch itself, you will probably have to tell the phones which VLAN they belong to.
I assume as a pre-requisite that the switch has configured both tagged and untagged vlans assigned to all ports, even the uplink ports.
Now assuming that is setup correctly, goto the phones themselves ;
1. press the settings button
2. unlock them with the keyboard command **#
3. set their Admin. VLAN Id to the tagged vlan number that is used for voice traffic. You will have to find that option , most likely under the Network Configuration settings.
Save those changes. See if that makes a difference.
regards Dave
09-09-2010 08:50 AM
Thanks for your help Dave, everything worked great!
best,
Jose
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide