H323 Block call on ANI

Answered Question
Sep 8th, 2010

Currently I have the a inbound translation pattern which translates the called number from 10 to 6.  Translation profile which is applied as imcoming to the pots dial peer is .

I need to block a few numbers based on originating ANI.  I have made new translation rules to reject the numbers, and they do work.

Can I have a translate called, and a translate calling  on the same profile / dial peer.

Voice translation-rule 12

rule 1 /41625\(.....\)/ /1\1/

Voice translation-rule 13

rule 1 reject /^(10 digit number)/

Voice translation-profile XXXX

translate calling 13

translate called 12

Is this possible?  Thanks

I have this problem too.
0 votes
Correct Answer by William Bell about 6 years 4 months ago

You can have translate called and calling directives on the same translation

profile. Though, I think that when you are doing a call rejection this

configuration approach doesn't apply. I block calls using the "call-block"

command under the pots dial-peer. This is evaluated independently of a

translation. Or at least that is my understanding.

HTH.

Regards,

Bill

On 9/8/10 5:44 PM, "balitewiczp"

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (3 ratings)
Loading.
Correct Answer
William Bell Wed, 09/08/2010 - 15:02

You can have translate called and calling directives on the same translation

profile. Though, I think that when you are doing a call rejection this

configuration approach doesn't apply. I block calls using the "call-block"

command under the pots dial-peer. This is evaluated independently of a

translation. Or at least that is my understanding.

HTH.

Regards,

Bill

On 9/8/10 5:44 PM, "balitewiczp"

balitewiczp Thu, 09/09/2010 - 06:36

Thanks for the info and quick response.  Using called blocking command worked very nicely.

Actions

This Discussion