09-09-2010 06:13 AM - edited 03-21-2019 02:58 AM
I need one of the FXS ports to be an ephone. That should be accomplished by changing the analog port to a user phone but it is not working. Where do the MAC addresses come from that are used for the FXS ports where I could manually put it back in?
Solved! Go to Solution.
09-09-2010 09:01 AM
Do you have STCAPP configured for the FXS port? If so, you can issue the command "show stcapp device summary". This will show you the MAC address of each SCCP controlled port.
Hope this helps.
Brandon
09-09-2010 09:01 AM
Do you have STCAPP configured for the FXS port? If so, you can issue the command "show stcapp device summary". This will show you the MAC address of each SCCP controlled port.
Hope this helps.
Brandon
09-09-2010 02:11 PM
Thanks for the help. Once I added the stcapp service, it added the ephone.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: