Commands to Verify Transcoder config and sessions.

Unanswered Question
Sep 9th, 2010
User Badges:

I have configured numerous 28XX for transcoding resource on various versions of callmanger and they work fine. However I have never been able to view the live transcoding rtp sessions as they occur on the router (28XX). I know that the transcoder is doing its job - as i can browse to the IP address of the Cisco phone and see that it rtp stream terminates on the transcoding router (28XX). I would however love to know the command to view the transcding sessions that are currently being used on the router (28XX). I have tried many show commands that i can see on the router without success, Can any one help??


Over the years I have used various levels of IOS - so I am sure its not a buggy IOS.


Thanks In advance Mark

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rob Huffman Thu, 09/09/2010 - 10:02
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Mark,



Have you tried;


show voice dsp group all


show voice dsp detailed


show dspfarm dsp active




Hope this helps!

Rob

wrightmp Mon, 09/13/2010 - 02:59
User Badges:

Hi - I will try and update all.


Many Thanks Mark

William Bell Thu, 09/09/2010 - 11:12
User Badges:
  • Purple, 4500 points or more

Mark,


Wouldn't "show sccp connections" give you the data you are looking for? Or

is there something missing? I know I have used it for TRP/MTP and CFB

recently. Can't recall the last time I looked at a hardware transcoded

session.


HTH.


Regards,

Bill



On 9/9/10 12:53 PM, "wrightmp"

Actions

This Discussion