setup CME to CUBE

Unanswered Question
Sep 10th, 2010
User Badges:

Hello,

i want to setup a CME which has a SIP trunk to a CUBE.

Both are running in my test lab.


Can anyone help me with the configuration of both? Do i need to setup a User Agent on both or only on the CME?


Thanks in advance.


regards, Marty

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Felipe Garrido Sat, 09/11/2010 - 08:54
User Badges:
  • Cisco Employee,

You'll just need to configure dial-peers to point calls between the two devices. There is no need to register anything.


On the CME it should look something like this,


Inbound dial-peer:


dial-peer voice 1 voip

incoming called-number

session protocol sipv2

dtmf-relay rtp-nte

codec g711ulaw

no vad



Outbound dial-peer:

dial-peer voice 2 voip

destination-pattern 9T

session protocol sipv2

session target ipv4:

dtmf-relay rtp-nte

codec g711ulaw

no vad


You'll need to configure a translation rule to strip off the 9 either on the CME or CUBE.


Similar dial-peers will need to be configured on the CUBE.


-Felipe

Actions

This Discussion