Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1204
Views
0
Helpful
1
Replies

setup CME to CUBE

martyveerdonk
Level 1
Level 1

‎09-10-2010 05:18 AM - edited ‎03-17-2019 10:06 PM

Hello,

i want to setup a CME which has a SIP trunk to a CUBE.

Both are running in my test lab.

Can anyone help me with the configuration of both? Do i need to setup a User Agent on both or only on the CME?

Thanks in advance.

regards, Marty

Labels:
0 Helpful
1 Reply 1

Felipe Garrido
Cisco Employee
Cisco Employee

‎09-11-2010 08:54 AM

You'll just need to configure dial-peers to point calls between the two devices. There is no need to register anything.

On the CME it should look something like this,

Inbound dial-peer:

dial-peer voice 1 voip

incoming called-number

session protocol sipv2

dtmf-relay rtp-nte

codec g711ulaw

no vad

Outbound dial-peer:

dial-peer voice 2 voip

destination-pattern 9T

session protocol sipv2

session target ipv4:

dtmf-relay rtp-nte

codec g711ulaw

no vad

You'll need to configure a translation rule to strip off the 9 either on the CME or CUBE.

Similar dial-peers will need to be configured on the CUBE.

-Felipe

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents