mirober2 Fri, 09/10/2010 - 09:02
User Badges:
  • Cisco Employee,

Hello,


It sounds like you don't have standby IP addresses configured for the interfaces. You can do this with the following command under the interface config:


ip address standby


When you configure those, you should see them listed in the 'show ip address' output.


Hope that helps.


-Mike

m.ancheta Fri, 09/10/2010 - 09:17
User Badges:

I have all my ip address showing in the primary

System IP Addresses

           ip address eobc 127.0.0.81 255.255.255.0
        ip address inside 10.254.15.4 255.255.255.248
        ip address WiFi-Proxydmz 10.254.50.5 255.255.255.0
        ip address enterprisedmz 10.254.15.17 255.255.255.248
        ip address fimsdmz 10.254.36.1 255.255.255.0
        ip address failoverdmz 10.254.15.9 255.255.255.248

but if i am on the secondary, i only see:

System IP Addresses:
        ip address eobc 127.0.0.81 255.255.255.0
        ip address failoverdmz 10.254.15.9 255.255.255.248
Current IP Addresses:
        ip address eobc 127.0.0.81 255.255.255.0
        ip address failoverdmz 10.254.15.10 255.255.255.248


All my failover commands for secondary unit are in there.

mirober2 Fri, 09/10/2010 - 09:49
User Badges:
  • Cisco Employee,

Hi Manny,


Looks like we have a TAC case open for this together as well : ) Let's troubleshoot under the TAC case and we can post the answer for the rest of the folks once we get it solved.


-Mike

Actions

This Discussion

Related Content