09-13-2010 03:32 AM - edited 03-10-2019 05:23 PM
Hello again!
As mentioned in another post here, I'm trying to set up both machine authentication and user authentication. But I'm puzzled by one of the Failure Reasons ACS gives me:
"The client's supplicant sent an EAP-Response/NAK packet rejecting the EAP-based protocol that was previously proposed for the inner method, and requested to use EAP-TLS instead. However, ACS does not allow EAP-TLS under PEAP configuration in the Allowed Protocols section of the corresponding Access Service."
09-14-2010 10:59 AM
ACS v5.1 does not support EAP-TLS.
In v5.0, you can see only PEAP with MSCHAPv2 is supported in the link below.
In ACS5.1, PEAP with GTC is added.
I did not see EAP-TLS is in ACS 5.1.
09-17-2010 03:11 AM
Hi, and thanks for answering.
Yes, there seems to be a lot missing in this peace of software, I'm *this* close to letting it go, and find another RADIUS server to use.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide