09-13-2010 06:27 AM - edited 03-06-2019 12:56 PM
Hi,
We would like to connect a 10Gb X2 and a TwinGig X2 to the same Supervisor (WS-X45-SUP6-E) is this possible. The release note are a little vague.
thanks
Andreas
09-13-2010 10:37 AM
Hi Andreas,
According to the datasheet you can do 10Gig or 1Gig (using the TwinGig) on either slot. So yes, you should be able to do 1 10Gig and 2 1Gigs.
Here is more info:
HTH
Reza
09-13-2010 11:46 AM
Hi Reza,
Thanks for the reply.
I also have that datasheet but there seems to be conflicting documents if you see below:
This says there is a limitation.
So im having trouble to to clarify this and i dont have the equipment to test this.
thanks
Andreas
09-13-2010 12:16 PM
Hi Andreas,
After reading the link you posted, it seems that you can only do 10Gigs or 1Gigs and not a mix of both, but than again to be sure, it needs to be test it.
Thanks,
Reza
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: