anyconnect and Active Directory

ARMANDO ALVARADO · ‎09-13-2010

Had anyone done a anyconnect and active directory setup. Still a little lost. I got the vpn working fine with ldap and staff can login fine. My next task is to get them to get there drive mappings. What would be the easiest or most common way of doing this.

Jason Gervia · ‎09-13-2010

Check out

https://supportforums.cisco.com/docs/DOC-1361#Q_Can_you_run_a_logon_script_after_AnyConnect_establishes_a_VPN_connection_Rather_than_running_Start_Before_Logon_SBL_which_must_be_run_every_time_I_start_the_computer_whether_or_not_I_want_to_VPN_I_would...

Anyconnect now support running a script after logon.

--Jason

ARMANDO ALVARADO · ‎09-14-2010

Jason,

I read that anyconnect version 2.4 and above does support this or is this incorrect from cisco..

Jason Gervia · ‎09-14-2010

Anyconnect scripting supports starts in AC 2.4 and above. there should also be examples (one of them does drive mapping) on the anyconnect download site.

--jason

ARMANDO ALVARADO · ‎09-14-2010

Jason,

Are you talking about the download software site for the AC correct.

BARRY GROSS · ‎09-13-2010

I have an anyconnect profile setup using SBL that logs into my directory just as if it were onsite. if you own the machines this is the method I would go.

-Barry

ARMANDO ALVARADO · ‎09-14-2010

Thank You Berry I will talk with our system adminstrators and possbile check this avenue out.