Need assistance configuring a second two port VWIC card

Unanswered Question

I have a 2811 with two single T1 VWIC cards bonded together as a multilink. I installed a two port VWIC T-1 card and unable to configure, running configuration shows !card type command needed for slot/vwic-slot 0/2. When I try to configure the card type, I get the following message, Card in slot 2 was removed or does not support command. Show diag shows WIC Slot 2: VWIC2-2MFT.

Help please.

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion