09-13-2010 12:36 PM
Hi all,
I have a doubt about disk replacement in NME-WAE, when I have a problem with the disk and I have to put a new one: how I make to install the waas OS in the new disk?
Thanks for your help,
Guzmán
Solved! Go to Solution.
09-13-2010 01:56 PM
Hi Guzman,
Here you go...
Start from:
To reinstall the system software on an NME-WAE network module installed in a Cisco access router, follow these steps:
......
....
...
Hope this helps.
Regards.
PS: Please mark this Answered, if this answers your question.
09-13-2010 01:56 PM
Hi Guzman,
Here you go...
Start from:
To reinstall the system software on an NME-WAE network module installed in a Cisco access router, follow these steps:
......
....
...
Hope this helps.
Regards.
PS: Please mark this Answered, if this answers your question.
09-13-2010 02:16 PM
Thanks for your help Bhavin, I read about this procedure but I want to be sure before proceed. This is only useful if I don't have problems with the Flash, isn't it?
If I have problems with the FLASH or the files there, I have to use the .sysimg image, isn't it?
Thanks again,
Guzmán
09-13-2010 02:19 PM
Yes, .sysimg will be useful for flash only but .bin also contains the flash image as well.
Regards.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: