09-13-2010 12:36 PM
Hi all,
I have a doubt about disk replacement in NME-WAE, when I have a problem with the disk and I have to put a new one: how I make to install the waas OS in the new disk?
Thanks for your help,
Guzmán
Solved! Go to Solution.
09-13-2010 01:56 PM
Hi Guzman,
Here you go...
Start from:
To reinstall the system software on an NME-WAE network module installed in a Cisco access router, follow these steps:
......
....
...
Hope this helps.
Regards.
PS: Please mark this Answered, if this answers your question.
09-13-2010 01:56 PM
Hi Guzman,
Here you go...
Start from:
To reinstall the system software on an NME-WAE network module installed in a Cisco access router, follow these steps:
......
....
...
Hope this helps.
Regards.
PS: Please mark this Answered, if this answers your question.
09-13-2010 02:16 PM
Thanks for your help Bhavin, I read about this procedure but I want to be sure before proceed. This is only useful if I don't have problems with the Flash, isn't it?
If I have problems with the FLASH or the files there, I have to use the .sysimg image, isn't it?
Thanks again,
Guzmán
09-13-2010 02:19 PM
Yes, .sysimg will be useful for flash only but .bin also contains the flash image as well.
Regards.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide