Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
410
Views
0
Helpful
1
Replies

3G connect with Failover

anthony.dyne
Level 1
Level 1

‎09-13-2010 11:52 PM - edited ‎03-04-2019 09:45 AM

Hi2All

SP is proposing Wireless WAN for backup connectivity for existing Wired connection, i.e 3G connect for branch office connectivity. Recommended router is 1841. Can I get configuration assistance for 3G to act as failover for primary link. 3G connection would be over public network and need to establish ipsec gre tunnel. OSPF is dynamic routing protocol

best wishes

Anthony

Labels:
0 Helpful
1 Reply 1

ashok_boin
Level 5
Level 5

‎09-14-2010 02:01 AM

Hi,

You require generic backup interface configuration with "backup commands" on the Cellular interface.

Pls refer the config guide below.

http://www.cisco.com/en/US/docs/routers/access/1800/1861/software/feature/guide/mrwlsgsm.html#wp1237405

The above link gives backup DDR for Cellular interface as primary. But the same approach you can follow to configure the cellular as backup to a primary interface.

Hope it helps...

Regards...

-Ashok.


With best regards...
Ashok
0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card