cisco 4506 PBR failure detection solution ?

Unanswered Question
Sep 14th, 2010
User Badges:

hi all


I use PBR to redirect traffic to wae in cisco 4506

4506 IOS ver is enterprise12.2(46) SG

supervisor 4


in waas configuration guide

when use PBR to redirect traffic to wae

it have 3 method to verify wae is available

but the sample configuration are all in router environment

it use command "set ip next-hop verify-availability 1.1.1.1 track 1"

to verify wae status


but

in 4506, it has not command "verify-availability"

although, I use ip sla to track wae status


cisco 4500 series is common use in small business

could anyone please share the solution to solve this question with me


thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Bhavin Yadav Wed, 09/15/2010 - 10:52
User Badges:
  • Cisco Employee,

Hi Chia,

You may want to take this question in Lan Switching Routing forum as it is related more to the Lan Switching / Routing commands and references..


https://supportforums.cisco.com/community/netpro/network-infrastructure/switching


About the WAE setup, all it cares in line setup is to pass the traffic in transparent way. In the WCCP / PBR setup, all it does is receives the traffic and sends it back out to the origin tunnel interface / default gateway depending on your configuration.


Hope this helps.

Regards.

Actions

This Discussion