cisco 4506 PBR failure detection solution ?

chia hao chang · ‎09-14-2010

hi all

I use PBR to redirect traffic to wae in cisco 4506

4506 IOS ver is enterprise12.2(46) SG

supervisor 4

in waas configuration guide

when use PBR to redirect traffic to wae

it have 3 method to verify wae is available

but the sample configuration are all in router environment

it use command "set ip next-hop verify-availability 1.1.1.1 track 1"

to verify wae status

but

in 4506, it has not command "verify-availability"

although, I use ip sla to track wae status

cisco 4500 series is common use in small business

could anyone please share the solution to solve this question with me

thanks

Bhavin Yadav · ‎09-15-2010

Hi Chia,

You may want to take this question in Lan Switching Routing forum as it is related more to the Lan Switching / Routing commands and references..

https://supportforums.cisco.com/community/netpro/network-infrastructure/switching

About the WAE setup, all it cares in line setup is to pass the traffic in transparent way. In the WCCP / PBR setup, all it does is receives the traffic and sends it back out to the origin tunnel interface / default gateway depending on your configuration.

Hope this helps.

Regards.