Is there way to display the a standard TCP/UDP port number(s) defined in a ASA/PIX?
for example, when creating an object-group
FWNAME(config-service)# service-object tcp ?
dual-service-object-group mode commands/options:
<0-65535> Enter port number (0 - 65535)
eq Port equal to operator
gt Port greater than operator
How do i find out the numerical values tied to those names?
Thanks in advance
In short, no.
Those are names for well known ports. Configuration guide is always a good place to start if you don't know which one is which.
Have a look here: