Error message %SIP-3-BADPAIR:...AS5250??

Unanswered Question
Sep 15th, 2010

I am getting this error on my 5350 cant figure out what it means yet. Has anyone seen this?

Sep 15 15:42:43.348: %SIP-3-BADPAIR: Unexpected event 16 (SIPSPI_EV_CC_CALL_MEDIA_CHANGED) in state 4 (STATE_RECD_PR          OCEEDING) substate 0 (SUBSTATE_NONE)


Cisco AS5350 (R7K) processor (revision T) with 131072K/65536K bytes of memory.
Processor board ID JAE0609066A
R7000 CPU at 250MHz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache
Last reset from power-on
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x32,
Board Hardware Version 3.33, Item Number 800-5171-02,
Board Revision B0, Serial Number JAE0609066A,
PLD/ISP Version 2.2,  Manufacture Date 2-Mar-2002.
Processor 0x14, MAC Address 0007.eb59.2412
Backplane HW Revision 1.0, Flash Type 5V
2 FastEthernet interfaces
106 Serial interfaces
108 terminal lines
4 Channelized T1/PRI ports
512K bytes of NVRAM.
32768K bytes of processor board System flash (Read/Write)
8192K bytes of processor board Boot flash (Read/Write)

Configuration register is 0x2102

thanks!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
byrne Wed, 09/15/2010 - 14:33

These messages are benign and shouldn't have any effect on the call.

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsa65535

CSCsb72851 Bug Details
%SIP-3-BADPAIR: Unexpected event 16 .... displayed w rmt txfr FXS calls.

Symptom:

The following messages are seen during call transfer using the CME and fxs phones,

%SIP-3-BADPAIR: Unexpected event 16 (SIPSPI_EV_CC_CALL_MEDIA_CHANGED) in state 4
(STATE_RECD_PROCEEDING) substate 0 (SUBSTATE_NONE)

%SIP-3-BADPAIR: Unexpected event 16 (SIPSPI_EV_CC_CALL_MEDIA_CHANGED) in state 11
(STATE_RECD_INVITE) substate 0 (SUBSTATE_NONE)
LP_CME_3#


Conditions:

These messages are benign and shouldn't have any effect on the call.

bsoth Wed, 09/15/2010 - 14:49

Ok fair enough. I was worried that it had something to do with the AS5350

going unresponsive. My associate rebooted the device before I could get a sh tech or some log messages. the device went awol yesterday. the device was completely offline. Ethernet was down and no calls being sent. Unfortunately I dont know if it was just something as simple as a switchport failure, cable failure, or perhaps a problem in IOS somewhere that would cause the device to hose up.

Would the show tech show anything after the device was back online? I cant really interpret all the info it provides.

the device is working fine today but unfortunately w dont know what happened. Im watching the logs cloely today to see if I can  catch it next time.

thanks

b

Actions

This Discussion