AP's cannot join controller while it is restarted

Unanswered Question
Sep 16th, 2010
User Badges:

Hi ,

I'm using WLC 2106 and 1130 AP's

They're working perfectly, but when I restart the WLC ( while AP's are on, because they have their on power supply ), they cannot join the controller afterwards

Then i need to manualy restart also AP's and after that they join controller.

It's strange because they all have their own static ip addreses , and the MGMT interface address of the WLC is on the same subnet

So is there aby solution ?

It's not easy to restart AP's all the time somewhere on the ceiling ; )


thanks


pet

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Leo Laohoo Thu, 09/16/2010 - 15:16
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Depends on the firmware.

peter_jevos Thu, 09/16/2010 - 15:32
User Badges:

thank you for your answer


WLC: Software Version                 5.2.193.0

AP-s IOS: 12.4(18a)JA2

Leo Laohoo Sun, 09/19/2010 - 02:12
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Cisco's been recommending everyone to stay away from the 5.X and 6.X codes.  Please upgrade to the 7.X code.

Actions

This Discussion