I have two questions.
I recently purchesed quite a few number of HWIC-1T cards. In the Cisco website, it stated that it can support upto 8Mbps speed. But when i connect to the Router, the speed is showing as 1544Kbps. Why is this? How can i acheive 8Mbps?
The second question is, I have few HWIC-4T card also. Cisco documents says, it can support Mbps per port. Where as the Cisco router shows the speed as 2Mbps. How can i acheive 8Mbps?
If i change bandwidth using 2bandwidth 8000" command, will that do the job?
You are correct - the router interface is operating in the DTE mode and adapts itself to the clocking provided by the opposite device. In this case, you cannot control the clockrate yourself. You are literally at the "mercy" of the DCE device.