Add a 0 (Zero) to Incoming CLI

Unanswered Question
Sep 17th, 2010
User Badges:

Hi Guys


I've searched the net and tried various things but I cannot seem to get this to work on our UC520.


I basically just need to add a 0 to incoming CLI so that I can match them against numbers in the directory and also to enable re-dialing.


I've tried adding a rule like rule 1 /^.*/ /0\0/ to the translation profile attached to my incoming DDI but its not working so I guess Im adding it in the wrong place. To make things aukward I set the system up using CCA so theres probably a lot of cruft in the config.


I've attached my config file with passwords removed if someone wouldnt mind having a look.


I'm a beginner to this so go easy on me


Thanks in advance.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Steven Holl Mon, 09/20/2010 - 08:29
User Badges:
  • Cisco Employee,

You're profile and rule look fine.


Do you have translate_calling applied to your inbound POTS dial-peer?


Use 'debug voip ccapi inout' to see what inbound dial-peer is matched, and apply 'translation-profile in translate_calling' to that peer.  If you already have a translation profile inbound applied to the inbound peer which you find you are matching, then just add ' translate calling 75' to whatever profile is already there.

Actions

This Discussion