For some reason when I compare backup and active ACE4710 certs size I have a size mismatch on 2 certs. I have done everything I can think of to elimanate this mismatch in size. I start off on the active with crypto import terminal xyz.pem which then a show crypto files displays as say 1800 then through a console session with putty I attach to the backup where i use the export from the master and run the same import command then show crypto file again where there is a significant file size difference. Could this be as a result of the serial connection versus the telnet session otherwise on the master? I know that the master is using the correct file size cert as it is up and tested where unless I do a failover to the backup I do not know the cert will work and as well crypto verify shows both sets match on active and backup? Right now I am in a warm standby state for ft as a result. Thanks.