Strange message at the end of booting Cisco1841

Answered Question
Sep 21st, 2010

Hello,

When we upgraded to IOS c1841-ipbasek9-mz.124-22-YB5 and reloaded the router we received following messages at the end of the boot process:

licensing flash block 0 needs to be initialized

licensing flash block 1 needs to be initialized

licensing flash block 0 needs to be initialized

licensing flash block 1 needs to be initialized

Does anyone know what this means.

Thank you in advance

Dimitri

I have this problem too.
1 vote
Correct Answer by vragotha about 6 years 2 months ago

Dimitri,

      This usually happens when unused parts of the Flash are being accessed. Try these steps

1. Reload the router again.

2. If the message appears again, format the flash and reload the IOS

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
vragotha Tue, 09/21/2010 - 07:12

Dimitri,

      This usually happens when unused parts of the Flash are being accessed. Try these steps

1. Reload the router again.

2. If the message appears again, format the flash and reload the IOS

dvangyzeghem Tue, 09/21/2010 - 07:39

hi Vijay,

Thank you for your reply.

When we reloaded the device the messages did not appear anymore.

So i presume this is just a notification message and cannot cause any problems?

Thanks again

Actions

This Discussion