Hi guys,
I have a working setup but I am wondering why I don't have any statistics available on my VFC interfaces.
lct-n5kup# show int counters fc brief
-------------------------------------------------------------------------------
Interface Input (rate is 5 min avg) Output (rate is 5 min avg)
--------------------------- -----------------------------
Rate Total Rate Total
MB/s Frames MB/s Frames
-------------------------------------------------------------------------------
fc2/1 406 498410707 0 29318484
fc2/2 349 464844989 0 27344026
fc2/3 396 459019674 0 27001360
fc2/4 387 393548081 0 23150082
fc2/5 388 415604111 0 24447500
fc2/6 389 406749980 0 23926672
fc2/7 389 378549906 0 22267834
fc2/8 399 409049454 0 24062162
-------------------------------------------------------------------------------
Interface Input (rate is 5 min avg) Output (rate is 5 min avg)
--------------------------- -----------------------------
Rate Total Rate Total
MB/s Frames MB/s Frames
-------------------------------------------------------------------------------
vfc1 0 0 0 0
vfc2 0 0 0 0
vfc3 0 0 0 0
vfc4 0 0 0 0
vfc5 0 0 0 0
vfc6 0 0 0 0
vfc7 0 0 0 0
vfc8 0 0 0 0
vfc9 0 0 0 0
vfc10 0 0 0 0
vfc11 0 0 0 0
vfc12 0 0 0 0
vfc13 0 0 0 0
vfc14 0 0 0 0
vfc15 0 0 0 0
vfc16 0 0 0 0
vfc17 0 0 0 0
vfc18 0 0 0 0
lct-n5kup# show int vfc 1
vfc1 is up
Bound MAC is 00:00:c9:d0:46:29
FCF priority is 128
Hardware is Virtual Fibre Channel
Port WWN is 20:00:00:0d:ec:e6:31:7f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port mode is F, FCID is 0x010006
Port vsan is 546
5 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors
0 frames output, 0 bytes
0 discards, 0 errors
Interface last changed at Tue Sep 21 13:47:13 2010
Again everything is working fine but I do not have any statistics on my VFCs.
Any hints on that?
Thanks a lot!
