AIR-LAP-1231G-A-K9 Problem with light weight commands on access point

Unanswered Question
Sep 21st, 2010

Hi All

I got a issue with AP 1231g it wont take any Light weight commands after I conected to the controller any help is good....

I reset the item too default same issue....  in about 10 AP.

thanks guys



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Leo Laohoo Tue, 09/21/2010 - 15:10

If you are using 4.X and 5.X firmware, there are a lot of LWAP commands that are disabled.

juancarlosmartinez Wed, 09/22/2010 - 09:28

Thanks  I will ask more details,   I already ask that question to the customer.

but no answer back.....yet...

thanks a lot for you time too....

keep in touch.


George Stefanick Wed, 09/22/2010 - 10:06

There is little need to access the AP in lwapp mode unless you are manually priming or troubleshooting ...


This Discussion