09-21-2010 10:58 AM - edited 07-03-2021 07:12 PM
Hi All
I got a issue with AP 1231g it wont take any Light weight commands after I conected to the controller any help is good....
I reset the item too default same issue.... in about 10 AP.
thanks guys
sincerely
JC
09-21-2010 01:05 PM
What commands are you attempting to use ?
09-21-2010 03:10 PM
If you are using 4.X and 5.X firmware, there are a lot of LWAP commands that are disabled.
09-22-2010 09:28 AM
Thanks I will ask more details, I already ask that question to the customer.
but no answer back.....yet...
thanks a lot for you time too....
keep in touch.
cmartin_39
09-22-2010 10:06 AM
There is little need to access the AP in lwapp mode unless you are manually priming or troubleshooting ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide