I configured on router primary and backup ISP connections.
Everything works fine.
Unfortunately the automatically switching of the ISP only works when I will put off the plug from the cisco socket.
When the signal goes down from ISP router, CISCO do not want to push the traffic into backup ISP.
Tracert gives me information of the destination IP for example cisco.com but without addresses of hoops.
What to do now ??
If you only want to use primary connection and then use secondary only if primary fails you need to sort out your route-maps.
However main thing you need to do is use IP SLA to keep track of the next-hop for the primary and if that fails then it will fail over to the backup link. Basic IP SLA config -
ip sla monitor 1
type echo protocol ipIcmpEcho
frequency <-- how often do you want it to check the next-hop
ip sla monitor schedule 1 life forever start-time now
track 123 rtr 1 reachability
ip route 0.0.0.0 0.0.0.0 10.111.10.225 track 123
ip route 0.0.0.0 0.0.0.0 10.14.10.81 254
the above config will use the tracked route as long as the is responding. If it stops responding then IP SLA will remove the route from the routing table and then the floating static with an AD of 254 will be inserted into the routing table. If the primary next hop comes back up then IP SLA will remove the floating static and insert the tracked route again.
Let me know how you get on and if you have any problems.