Vinay Sharma Wed, 09/22/2010 - 05:29
User Badges:
  • Gold, 750 points or more

Hi k abillama,


Make sure you have connected to port 6 because port 2 and 5 are the (Blocked) Gigabit Ethernet.


http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.1/installation/guide/csacs_hw_ins.pdf


As you said that it worked initially but stop working after reload, it could be a hardware issue as well if the conneciton has been made as per document mentioned.


thanks,

Vinay

k.abillama Wed, 09/22/2010 - 07:12
User Badges:

Hi vinashar,


I double checked and it's correct! During the initial setup it was working but then and after reloading the appliance it didn't work anymore. The other interface is working normally. Could it be a bug?


Regards

Actions

This Discussion