Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
606
Views
0
Helpful
2
Replies

ACS 1121 Gigabit 0 not working

k.abillama
Level 1
Level 1

‎09-22-2010 03:34 AM - edited ‎03-10-2019 05:25 PM

Hi,

I have an ACS 1121 appliance newly shipped and the gigabit 0 interface worked initially but after reload it didn't anymore.

Any hints?

Regards

Labels:
0 Helpful
2 Replies 2

Vinay Sharma
Level 7
Level 7

‎09-22-2010 05:29 AM

Hi k abillama,

Make sure you have connected to port 6 because port 2 and 5 are the (Blocked) Gigabit Ethernet.

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.1/installation/guide/csacs_hw_ins.pdf

As you said that it worked initially but stop working after reload, it could be a hardware issue as well if the conneciton has been made as per document mentioned.

thanks,

Vinay

Thanks & Regards
0 Helpful

k.abillama
Level 1
Level 1
In response to Vinay Sharma

‎09-22-2010 07:12 AM

Hi vinashar,

I double checked and it's correct! During the initial setup it was working but then and after reloading the appliance it didn't work anymore. The other interface is working normally. Could it be a bug?

Regards

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents