UC540 and Valcom 2001A

Unanswered Question
Sep 22nd, 2010
User Badges:

I am having an issue with a Cisco UC540 and Valcom paging system


We get this hooked up and it seems to work fine, but after a few hours whenever you dial an outside line the button presses go out over the paging system


Anyone have any idea what I am doing wrong with this unit.


Thanks


James

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
David Hornstein Wed, 09/22/2010 - 08:15
User Badges:
  • Gold, 750 points or more

Hi James,


I have used a Valcom 9970 connected to a FXS line.


I guess the Valcom 2001A is connected to a FX0 line as the install instructions for the VALCOM 2201A shows the unit connected to a CO tip and ring.



I think the calls are routing to the Valcom when the other FX0 ports are busy.  Could this be the case  ?


Gotta use CCA to make sure that outgoing calls routing is not routed to that FX0 port.


But I must admit i prefer to use a VALCOM 9970 for single zone paging and connect it to a UC540 FXS port.


Then all I have to do is call a phone extension, like x301 to activate overhead paging.


regards Dave

vigomachine Wed, 09/22/2010 - 10:38
User Badges:

Thank you for pointing me in the right direction.


I found that the dial plan for local numbers had the page fxo port listed in it. None of the other plans had it.

Actions

This Discussion