09-22-2010 11:53 AM - edited 03-16-2019 12:56 AM
Hello,
I have performed a factory reset of a 7942 running 903 firmware.
However upon boot it now hangs on upgrading and does not seem to do anything
I have checked that the term42.default.loads and all its references files are on the tftp server
DHCP is working fine on this network port as I can plug in an operation phone.
Any ideas?
Thanks
09-22-2010 01:16 PM
Are you sending option 150 to the phone in the DHCP Offer.?
option 150 tells the phone where the TFTP server is.
09-22-2010 01:18 PM
On a cisco router this is how you set option 150
ip dhcp pool VLANX
option 150 ip
Add that piece of config to your cisco router and the router will sent option 150 with dhcp offers.!
Depending on your DHCP server the method to specify option 150 might differ.
09-22-2010 02:50 PM
Thanks for the response
DHCP is provided by MS DHCP server
I can plug a brand new out of the box phone into the same ethernet port and it works fine and gets its 150 from the MS DHCP server.
09-22-2010 10:07 PM
Is your problem solved?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: