Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
2457
Views
0
Helpful
4
Replies

7942 Factory Reset

ANDREW BERESFORD
Level 1
Level 1

‎09-22-2010 11:53 AM - edited ‎03-16-2019 12:56 AM

Hello,

I have performed a factory reset of a 7942 running 903 firmware.

However upon boot it now hangs on upgrading and does not seem to do anything

I have checked that the term42.default.loads and all its references files are on the tftp server

DHCP is working fine on this network port as I can plug in an operation phone.

Any ideas?

Thanks

Labels:
0 Helpful
4 Replies 4

dijohn
Cisco Employee
Cisco Employee

‎09-22-2010 01:16 PM

Are you sending option 150 to the phone in the DHCP Offer.?

option 150 tells the phone where the TFTP server is.

0 Helpful

dijohn
Cisco Employee
Cisco Employee

‎09-22-2010 01:18 PM

On a cisco router this is how you set option 150

ip dhcp pool VLANX

option 150 ip

Add that piece of config to your cisco router and the router will sent option 150 with dhcp offers.!

Depending on your DHCP server the method to specify option 150 might differ.

0 Helpful

ANDREW BERESFORD
Level 1
Level 1

‎09-22-2010 02:50 PM

Thanks for the response

DHCP is provided by MS DHCP server

I can plug a brand new out of the box phone into the same ethernet port and it works fine and gets its 150 from the MS DHCP server.

0 Helpful

dijohn
Cisco Employee
Cisco Employee
In response to ANDREW BERESFORD

‎09-22-2010 10:07 PM

Is your problem solved?

0 Helpful
Customers Also Viewed These Support Documents