FXO with pulse dialling

Unanswered Question
Sep 23rd, 2010

In Kiev, Ukraine.

I have 4 analogue lines connected on a 4 port FXO card. When connected to the Siemens PABX, all lines can call anywhere. When I connect the lines one by one to the same port on the gateway with the same configuration, I have only 1 line being able to make only local calls. I plug those lines 1 by one on an analog phone, with the setting to pulse, then all of them can also call anywhere. It does not make sense that I use the same port for testing via the CCM, and only 1 can dial and only local.

Any advice.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Steven Holl Fri, 09/24/2010 - 08:15

Can you get these debugs for a failure, so we can physically see why the second call fails?

debug voip ccpai inout

debug vpm sig

Also include:

sh run

sh voice call sum

Actions

This Discussion