6509-E: Aggregate bandwidth policing on access ports

Unanswered Question
Sep 25th, 2010
User Badges:

Hello.

What i would like to accomplish is to limit the aggregate input bandwidth to let's say 1G, to a certain subset of vlans configured on a 6509-E. Bare in mind that this device is not doing L3 termination and thus, all ports are access ports. Below is a snippet of the configuration:



mls qos aggregate-policer TEST-AGGR-LIMIT 1000000000 31250000 31250000 conform-action transmit exceed-action drop
!
class-map match-any TEST-AGGR-LIMIT-CLASS
  match vlan 1-500
  match vlan 510-4094
!
!
policy-map TEST-AGGR-LIMIT-POLICY
  class TEST-AGGR-LIMIT-CLASS
     police aggregate TEST-AGGR-LIMIT


interface GigabitEthernetx/y
switchport
switchport access vlan 3001
switchport mode access
load-interval 30
flowcontrol send off


When this policy is applied ingress on GiX/Y (access port), i am getting Match vlan is not supported for this interface.

Every help is greatly appreciated.


Best regards.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Kostas Kyriakos Sun, 09/26/2010 - 01:28
User Badges:

I tried matching source-address (mac) and every match criterion that made some sense under the class configuration but yet i am getting the previous unsupported for this interface notification.


Looking forward to your input.

Actions

This Discussion