6509-E: Aggregate bandwidth policing on access ports

Kostas Kyriakos · ‎09-25-2010

Hello.

What i would like to accomplish is to limit the aggregate input bandwidth to let's say 1G, to a certain subset of vlans configured on a 6509-E. Bare in mind that this device is not doing L3 termination and thus, all ports are access ports. Below is a snippet of the configuration:


mls qos aggregate-policer TEST-AGGR-LIMIT 1000000000 31250000 31250000 conform-action transmit exceed-action drop
!
class-map match-any TEST-AGGR-LIMIT-CLASS
  match vlan 1-500
  match vlan 510-4094
!
!
policy-map TEST-AGGR-LIMIT-POLICY
  class TEST-AGGR-LIMIT-CLASS
     police aggregate TEST-AGGR-LIMIT

interface GigabitEthernetx/y
 switchport
 switchport access vlan 3001
 switchport mode access
 load-interval 30
 flowcontrol send off

When this policy is applied ingress on GiX/Y (access port), i am getting Match vlan is not supported for this interface.

Every help is greatly appreciated.

Best regards.

Kostas Kyriakos · ‎09-26-2010

I tried matching source-address (mac) and every match criterion that made some sense under the class configuration but yet i am getting the previous unsupported for this interface notification.

Looking forward to your input.