I am tasked to configure this router and deploy to our remote office in Samoa but I am having difficulty gettting the switchpart to work. From the router console, I can ping outside but a pc plugin to the switchport is not seeing outside. Is there a specific config for the switchports other than VLAN, speed and duplex?
See config below:
description Trunk to Router
ip address xx.xx.xx.xx 255.255.255.252
description WORKSTATION VLAN
encapsulation dot1Q 100
ip address xx.xx.xx.xx 255.255.255.0
ip helper-address xx.xx.xx.xx
switchport access vlan 100
I appreciate any help on this. I have until tomorrow morning to figure this out.