Cannot Access WLC 4404 Administration page using https

Unanswered Question
Sep 28th, 2010


We have recently upgraded the software on our two WLC 4404 from software release to to and lastly to version

We could access the WLC's GUI's using https when it was on version When we did the upgrades from version to we couldn't access the Admin page through https anymore but only through normal http. We enabled https through the GUI and through the CLI and we did do the re-generation certificate , without any success. We then upgraded to version and we still have the same result , cannot access Admin GUI through https.

Any suggestions ?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
bbxie Tue, 09/28/2010 - 03:40

I rember met similar issue long time ago when upgraded from 4.x to 5.0.x(can't remember the exact version), at that time it was because of the intermediate version had bug, there are some certain intermediate version needed.

In your case, you can try to downgrade WLC to the initial, then upgrade from to 4.2.176, then upgrade to 7.0.98.

Vinay Sharma Sun, 09/25/2011 - 10:47

Hello Jakes,

Please mark the Question as Answered, if the provided information by BoXie is correct and it helped. By doing that others can take benefit as well.


Vinay Sharma

Community Manager – Wireless


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode