09-28-2010 01:03 AM - edited 07-03-2021 07:13 PM
Hi
We have recently upgraded the software on our two WLC 4404 from software release 4.0.xxx to 4.2.xxx to 6.1.199.4 and lastly to version 7.0.98.0.
We could access the WLC's GUI's using https when it was on version 4.0.xxx. When we did the upgrades from version 4.2.xxx to 6.1.199.4 we couldn't access the Admin page through https anymore but only through normal http. We enabled https through the GUI and through the CLI and we did do the re-generation certificate , without any success. We then upgraded to version 7.0.98.0 and we still have the same result , cannot access Admin GUI through https.
Any suggestions ?
Jakes
09-28-2010 03:40 AM
I rember met similar issue long time ago when upgraded from 4.x to 5.0.x(can't remember the exact version), at that time it was because of the intermediate version had bug, there are some certain intermediate version needed.
In your case, you can try to downgrade WLC to the initial 4.0.xxx, then upgrade from 4.0.xxx to 4.2.176, then upgrade to 7.0.98.
09-25-2011 10:47 AM
Hello Jakes,
Please mark the Question as Answered, if the provided information by BoXie is correct and it helped. By doing that others can take benefit as well.
Thanks,
Vinay Sharma
Community Manager – Wireless
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: