09-28-2010 01:36 AM - edited 03-11-2019 11:46 AM
Hello I have a problem with NAT,
the original config works fine (two lines below)
nat (inside) 1 10.149.0.0 255.0.0.0
global (outside) 1 62.206.190.254
Additional I want to NAT the inbound traffic for a customer from outside 172.16.X.X to 10.149.241.20-10.149.241.254 but when I type in the two lines below,
I get an error message like no translations group found.
global (inside) 2 10.149.241.20-10.149.241.254 netmask 255.255.255.0
nat (outside) 2 172.16.0.0 255.255.0.0 outside
I have no idea what went wrong.
Many thanks for your help
09-28-2010 01:57 AM
I think for your inbound traffic (outside to inside) you will require a static nat translation.
e.g.
static (outside,inside) 10.149.241.0 172.16.0.0 netmask 255.255.255.0 0 0
09-28-2010 02:14 AM
Thank you for your help ,
but I want to NAT dynamic addresses, without using static.
09-28-2010 08:54 AM
Hi,
Can you past the exact error message you are getting? Also, please try running a packet-tracer from the outside to the inside and send that output as well.
Thanks and Regards,
Prapanch
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide