CSS10500 Load Balancing Multiple Hosts

Answered Question
Sep 28th, 2010

Hello,

I have a CSS10500 switch and i would like to load balance the connections to a couple of hosts. My setup (roughly) is as follows


int e1-RTR1-------->int e2-Host1

                 -------->int e3-Host2

and

int e5-RTR2------>int e6-Host1

                 ------>int e7-Host2

How can i assing different interfaces to the two sets of hosts??? I want all ports (0-65535 and tcp/udp)  to go to both sets. I made a circuit vlan 1 and assigned it an ip address but i cannot make a circuit vlan 2 and when i assign multiple addresses to vlan1 i cannot somehow assign interfaces to each ip.

Is there anything i can do??

Sorry for all the fuss i am new to the CSS concept.

I have this problem too.
0 votes
Correct Answer by Gilles Dufour about 6 years 3 months ago

Let's start with the basic

http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_configuration_example09186a008009438d.shtml

If you can't make it work, get back to us with whatever you have configured.

Verify that you can ping the CSS from the router and the server.

Gilles.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.

Actions

This Discussion

Related Content