×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

CAD reserved status

Unanswered Question
Sep 28th, 2010
User Badges:

Hi,


I am having CCX 4.5, CCM 5.1, IP phone 7960 & IP Communicator.


Whenever call hits up on CAD through call flow, its status changes to Reserved & all icons of hold/unhold, conference, transfer get disabled.


This is happening to some users.


Can anyone help me to resolve this ??



Regards,

Nimit

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Aaron Harrison Wed, 09/29/2010 - 01:23
User Badges:
  • Super Bronze, 10000 points or more
  • Community Spotlight Award,

    Member's Choice, May 2015

Hi


Check that the CSS assigned to the CTI Ports for UCCX contains the agent DNs partition. This happens when UCCX tries to consult transfer to the agent, but cannot reach them.


If the CSS is OK, it can also be caused by anything else that would prevent the call - such as regions/locations for example.


Regards


Aaron


Please rate helpful posts...

Actions

This Discussion