We purchased an 3925 with a 16 port Gig SM module installed.

When I boot up router, those interfaces do not show up.

Do I have to do anything special to enable those interfaces to be seen on router.

(The 4th Gig interface show up as GI1/0, but I don't know where it is physicall located; possibly the SM Module itself ??)

Pertinent IOS information:

System image file is "flash0:c3900-universalk9-mz.SPA.150-1.M3.bin"

Cisco CISCO3925-CHASSIS (revision 1.1) with C3900-SPE100/K9 with 997376K/51200K bytes of memory.
Processor board ID FTX1434AJU9
4 Gigabit Ethernet interfaces
1 ATM interface
1 terminal line
1 Virtual Private Network (VPN) Module
DRAM configuration is 72 bits wide with parity enabled.
255K bytes of non-volatile configuration memory.
500472K bytes of ATA System CompactFlash 0 (Read/Write)

License Info:

License UDI:

-------------------------------------------------
Device#   PID                   SN
-------------------------------------------------
*0        C3900-SPE100/K9       FOC14314JJ5

Technology Package License Information for Module:'c3900'

----------------------------------------------------------------
Technology    Technology-package          Technology-package
              Current       Type          Next reboot
-----------------------------------------------------------------
ipbase        ipbasek9      Permanent     ipbasek9
security      securityk9    Permanent     securityk9
uc            None          None          None
data          None          None          None

Configuration register is 0x2102

Thanks for any help.

Tom