FXO Voice ports remains off-hook after conference CME 7.1

Unanswered Question
Sep 28th, 2010
User Badges:


I have an issue that is really a headache for end users. I have CME 7.1 con 4 FXO ports.

when any user set a conference (3 parties, 1 internal and 2 PSTN phone numbers), after finishing the conference the fxo ports remains off-hook.

If I type "sh voice call status" the information shown the phone numbers dialed (PSTN phones)  for the previous conference even though the conference has been finished.

also, if I type " sh voice port summary" I see the fxo ports in use but I know there is no calls stablished.

CME info

Version 12.4(24)T3

System image file is "flash:c2801-spservicesk9-mz.124-24.T3.bin"

Cisco 2801 (revision 6.0) with 238592K/23552K bytes of memory.
Processor board ID FTX1046W2HK
2 FastEthernet interfaces
4 Voice FXO interfaces
1 DSP, 8 Voice resources
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
62720K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102

any idea about this issue?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion