09-28-2010 04:12 PM - edited 03-16-2019 01:04 AM
I am at a loss. I still cannot forward a call off-net from an off-net call. I have checked under service manager, not blocking. Tested multiple CSS settings, everything works as advertised. I can fwd off-net from an internal number fine. What am I missing.
Setup
CUCM 7.1.5
H.323 Gateways.
Thanks in advance
Rich
09-28-2010 04:32 PM
Hi
Please take a look at the following thread:
https://supportforums.cisco.com/message/3187809
Thanks
Tapan
09-28-2010 04:56 PM
Thanks for the pointing out.
But, this hasn't resolved my issue.
09-29-2010 04:16 AM
Take, "debug isdn q931" with "term mon" and post it here.
Do not take any other debug, do not use attachments.
09-29-2010 06:13 AM
Below is from my incoming gateway. I have 2, 1 in and 1 out. The outbound gateway doesn't see the call.
632199: *Sep 29 08:36:04.390 ET: ISDN Se0/0/1:23 Q931: RX <- SETUP pd = 8 callref = 0x0237
Bearer Capability i = 0x8090A2
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA9838F
Exclusive, Channel 15
Progress Ind i = 0x8283 - Origination address is non-ISDN
Calling Party Number i = 0x2181, 'XXXXXXXXXX'
Plan:ISDN, Type:National
Called Party Number i = 0x80, '3017'
Plan:Unknown, Type:Unknown
632200: *Sep 29 08:36:04.406 ET: ISDN Se0/0/1:23 Q931: TX -> CALL_PROC pd = 8 callref = 0x8237
Channel ID i = 0xA9838F
Exclusive, Channel 15
632201: *Sep 29 08:36:04.646 ET: ISDN Se0/0/1:23 Q931: TX -> DISCONNECT pd = 8 callref = 0x8237
Cause i = 0x809B - Destination out of order
632202: *Sep 29 08:36:04.686 ET: ISDN Se0/0/1:23 Q931: RX <- RELEASE pd = 8 callref = 0x0237
632203: *Sep 29 08:36:04.690 ET: ISDN Se0/0/1:23 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x8237
09-29-2010 06:45 AM
So after posting above I kind of stumbled on what I thought was going on. Seeing as I have 2 gateways I started checking to see if they were talking to each other. Well, my limited knowledge in that didn't come up with anything. So, for a temporary fix, I have created a new CSS, that uses a route pattern, which looks at a reversed ooutbound RG. So when a call comes in my inbound gateway, it gets turned right around and sent out the same gateway. I am going to use this as a temporary fix, but if someone can give me some insight on how to get this working properly I would be greatly appreciative.
Thanks
Rich
09-29-2010 07:44 AM
Very good, please remember to rate useful posts clicking on the stars below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: